Skip to main content

Centre d'aide Litepanels

[en] Control Menu

[en] The Studio LED X3 PLUS Bicolor is equipped with a backlit LCD which allows to set the fixture´s behaviour according to your needs, to display all of the information of the fixture and a Keypad to access and navigate through the menu.

[en] Use the LCD and keypad to program the fixture for your specific application.

[en] To split from DMX mode to Manual mode press [ESC/MODE] only when you are in the Home screen.

Control.jpg
  • [en] ESC/MODE] button used to leave the menu without saving changes. Double presses of the [ESC/MODE] button take you back in Home screen. In the Home Screen the button [ESC/ MODE] activate the Potentiometer for manual dimming.

  • [en] ENTER] button is used to enter the selected menu and to confirm adjusted parameter.

  • [en] [UP] button increases a parameter or menu choice by one. Pressing and holding the push button increases the rate of change.

  • [en] [DOWN] button decreases a parameter or menu choice by one. Pressing and holding the push button increases the rate of change.

  • [en] [POTENTIOMETER] is only active in Manual mode, the local potentiometers allows to control light intensity and CCT adjustment manually. The dimming level and the CCT are shown in the display.

  • [en] [USB] USB port is used to connect the Studio LED X3 PLUS Bicolor to a PC to upgrade the firmware, make a check up of the fixture, change the system parameters.

[en] After switching the fixture on, display shows current DMX address if the Studio LED X3 PLUS Bicolor is set in DMX mode or Manual mode if the Studio LED X3 PLUS Bicolor is set in local dimming, internal temperature of the array led, fan speed, graphic light intensity, percentage light intensity.